صن روف SYNROOF

MECHANICAL PROTECTION

Traffic roofs : Maximum protection can be achieved by insitu screed. Use a Kraft paper or polyethylene separation layer over the insulation boards. Then lay a topping screed of 4 cm to 5 cm thickness

Non-Traffic roofs : Place a non woven polyester separation layer BITUMAT BITUTEX, over the insulation boards. Then cover to a minimum depth of 5 cm with 15/30 gauge washed gravel. For thicker insulation boards, the gravel depth should at least be equal to that of the board thickness.

PRECAUTIONS

Bitumen or asphalt roof surfaces receiving a coating of BITUMAT SYNROOF should be thoroughly dry.

Never apply if rain is imminent.

Application at temperatures below +5° C may result in incomplete film formation, with reduced elasticity and the possibility of cracks forming.

Do not use BITUMAT SYNROOF on areas that will be constantly submerged in water.

التصنيف:

SYNROOF – Premium Quality Acrylic Waterproofing Coating

BITUMAT SYNROOF is a versatile acrylic elastomeric waterproofing coating. It cures to a highly flexible, tough, seamless membrane for the protection of all kinds of roofs.

INSTALLATION

SURFACE PREPARATION Roof and other surfaces must be thoroughly clean, dry, free from moss, dirt, oil, grease and loosely adhering materials. In case of metal surfaces, remove rust and contamination and apply a coat of anti-corrosive primer. To achieve best results, a fiber mesh reinforcing mat should be embedded into first coat of BITUMAT SYNROOF whilst still wet mainly at expansion areas and joints with parapet. Depending on the nature of substrate, a priming coat with BITUMAT SYNROOF diluted with 20% water may be required.

0/5 (0 Reviews)

المراجعات

لا توجد مراجعات بعد.

كن أول من يقيم “صن روف SYNROOF”

لن يتم نشر عنوان بريدك الإلكتروني. الحقول الإلزامية مشار إليها بـ *

منتجات ذات صلة

arالعربية
en_USEnglish arالعربية